![]() ![]() On this Mode, the Touch Capacitors of the FX knobs trigger the Effects while touched (same as FX TOUCH Mode), and additionally the EQ Touch Capacitors will kill the corresponding frequencies while touched. Press this button a second time to enable the EQ/FX TOUCH Mode. On this Mode the Touch Capacitors of the FX knobs trigger the Effects while touched. TOUCH EQ/FX (Left side): Press this button once to enable the FX TOUCH Mode.The Jogwheel also offers Loop In and Loop Out point adjustment (see Manual Loop Pads mode) Hold SHIFT down and then use the Jogwheel to fast search through the track, but keep the phase synced. Use the jogwheel to Scratch (if Vinyl mode is selected) or pitch bend. If you want to use the strip while a deck is on air please hold down SHIFT first, and then touch the strip. Important notice: In order to avoid accidental track jumps when you manipulate FX, the needle search does not operate when the deck is on air. Lift your finger from the strip to stop playback. While your finger touches the strip, the track will start a temporary playback (if it was not playing before) in order to preview that area of the track. Place your finger on a point along this sensor to jump to that point in the track (song position). STRIP SEARCH: The length of this strip represents the length of the entire track.DECK SWITCH: Press this button to toggle control between decks 1&3 for the left side or 2&4 for the right side.Hold SHIFT down and then press this button to set this deck as Master Deck (for 4 decks skins). SYNC: Press this button to automatically match the corresponding Deck's tempo and phase with the opposite Deck's (or the Master Deck’s if using a 4 decks Skin) tempo and phase.Press and hold SHIFT and then press this button to return to the beginning of the track. ![]() To continue playback without returning to the Temporary Cue Point, press and hold the Cue Button, then press and hold the Play Button, and then release both buttons. Releasing the Cue Button will return the track to the temporary Cue Point and pause it. If the Deck is paused, you can press and hold the Cue Button to play the track from the Temporary Cue Point. (If you did not set a Cue Point, then it will return to the beginning of the track.). During playback, you can press the Cue Button to return the track to this Cue Point. CUE: When the Deck is paused, you can set a temporary Cue Point by moving the Platter to place the Audio Pointer at the desired location and then pressing the Cue Button.Press and hold SHIFT and then press this button to "stutter-play" the track from the last set Cue Point. You can also check-out our Serato Software / Operating System compatibility chart, to learn more about general software compatibility. Or, check-out Sonny offering a short explanation: Using unsupported configurations outside of the recommendations below, may result in unforeseen issues and in some circumstances, your hardware may not operate with the software at all.įor further information, check-out Discontinued & limited hardware support information. This information may be useful when purchasing second-hand hardware, or when purchasing a new computer to use with your existing hardware. Below are the last supported configurations of operating systems and Serato DJ software, as they pertain to primary hardware & Serato official accessories. ![]()
0 Comments
Leave a Reply. |